Addresse
Rosenbergstrsse 17, 8200 Schaffhausen
Besuch nach Vereinbarung
SHOP
The Hacker R&D team led by renowned developer Martin Vilsmeier has once again scored a major success with this new Q80-11 PSD Senstrol!
Through an uncompromising redesign, they have succeeded in further improving the power-to-weight ratio. The overall length has been reduced to that of the Q80-XS.
The main reason why the available power is significantly higher with this specific motor than with the standard Q80 is the unique Senstrol technology. Not only are the motor and controller 100% matched to each other, but the motor is also driven by a true sine wave. This control method allows the motor to operate at higher power while simultaneously achieving greater efficiency, with less power loss and heat generation.
The test results speak for themselves: the new Q80-11 PSD Senstrol delivers up to 25% more power than its sibling, the standard Q80-11!
Just like every Q80, this Q80-11 PSD Senstrol is also hand-built, tested, and calibrated in-house by us.
"PSD" > "P"erformance, size "S," and "D"elta connection.
"Made in Germany" quality for the highest standards.
| Prop | Xoar CFRP 21x13 | Mejzlik 20x14EL 3-blade | Falcon 20x13.5 3-blade |
|---|---|---|---|
| V / LiPo | 37V = 10S LiPo | 37V = 10S LiPo | 37V = 10S LiPo |
| Amp. | 92A | 91A | 90A |
| Power | 3400W | 3367W | 3330W |
| RPM | 6480 | 6000 | 6270 |
| Controller | Master Senstrol 120A Opto | Master Senstrol 120A Opto | Master Senstrol 120A Opto |
| Technical Specifications | |
| Max. power in watts (max. 15 sec) | 3400 |
| Number of poles | 28 |
| Turns | 11 |
| No-load current (I0) at 8.4 V [A] | 1.1 |
| Internal resistance (Ri) [ohms] | 0.02 |
| Recommended timing [°] | Determined by ID chip |
| Recommended clock frequency [kHz] | Specified by ID chip |
| Recommended controller [A] (depending on setup) | Master Senstrol 120 |
| No-load speed per volt (kv) | 205 |
| Dimensions and weights | |
| Weight [g] | 620 |
| Length [mm] | 65.5 |
| Outer diameter [mm] | 88.5 |
| Shaft diameter [mm] | 8 |
| Scope of delivery / Features | |
| Shaft coupler | Yes |
| Gold connector mm (soldered) | 4 |
| Backmount compatible | No |
| Front mountable | Yes |
Bitte lesen Sie in der Artikelbeschreibung die Angaben zur Lieferzeit.
Die im Shop oder auf Preislisten angegebenen Lieferfristen oder Angaben über die Verfügbarkeit können sich kurzfristig ändern (z.B. Zwischenverkauf, Verzögerungen im Wareneingang und höherer Gewalt etc.). In diesen Fällen wird der Käufer umgehend informiert. Die Waren werden normalerweise am Folgetag des Bestell- oder Zahlungseingangs dem Transporteur übergeben. Lieferbenachrichtigungen und Liefertermine auf eine gewünschte Zeit sind kostenpflichtig.
Besuch nach Vereinbarung